Husqvarna PT26D Workshop Manual page 101

IMPORTANT INFORMATION
The circuit board must not be subjected to
breaking or bending strain
10. Carefully remove the circuit board.
11. If necessary, move over the strapping on
the rear of the circuit board to the new
circuit board.
12. Carefully fit the new circuit board in posi-
tion, make sure that it rests in the right
position before any of the nuts are tight-
ened.
13. Fit the nuts and tighten moderately, so
as not to damage the circuit board.
14. Fit the connections according to the
markings, make sure that the plastic
catches lock correctly.
15. Assemble the two switches and connect
them to the circuit board.
16. Position the rubber grommets for the
cable harnesses and assemble the
plate.
17. Connect the battery.
18. Test all electrical functions with the LEDs
on the circuit board.
19. Assemble the panel. Caution: Different
screws, threaded screws on top and self-
tapping screws underneath.
Replacing theindicator panel
IMPORTANT INFORMATION
When the plastic covers are removed, the
unit with warning lamps is released. Do not
damage it.
1. Remove the plastic covers (41+43)
around the steering wheel console.
2. Release the power cable (NOTE plastic
catch) and carefully lift of the indication
panel (39).
3. Assemble in reverse order.
4. Check the function. All lamps should
come on briefly when the ignition key is
turned.
100
English-
REPAIR INSTRUCTIONS
Headlight and indicator panel, parts
8043-130