Service; Service Schedule - Husqvarna Automower 405X Workshop Manual

7.1 Service schedule

The table below contains a checklist of points and actions to be taken when servicing the product.
Every Every Action
year 3rd year
Firmware update
X
If firmware is available in Autocheck, update the
product with the newest firmware.
Autotest
X
Diagnostic test of all product functions.
Service messages
X
Do a check of the service messages for recom-
mended upgrades.
Cleaning
Remove the body of the product. Clean the
X
body of the product, the chassis and the
wheels.
Charging plates
Examine the cable and connector to the charg-
X
ing plates on the body of the product. Replace if
damaged.
Rubber grommets
Examine the rubber grommets on the chassis
X
to make sure that they are completely sealed.
Replace if damaged.
Ventilation filter
Examine the ventilation filter and clean carefully
X X
with a soft brush. The ventilation filter should be
replaced after three years of use.
Hatch
X
Clean the area around the display cover hinge.
Bearings
X
Examine the rear wheel bearings. Replace if
damaged.
Wheels
X
Examine the front and rear wheels. Replace if
damaged.
Body suspension parts
X
Examine and clean the body suspension parts.
Bellows
Do a check of the rubber bellow in the cutting
X
height adjustment. Refer to
wheel motors on page 31 .

36 - Service

7 Service
Explanation
Refer to
Make a complete Autotest in Autocheck. Refer
Auto test on page 16 .
to
Updated service bulletins can be found in Au-
tocheck.
Refer to
page 19 .
Refer to
charging plates on page 21 .
Refer to
page 19 .
Refer to
ter on page 23 .
Refer to
31 .
Refer to
and
Refer to
parts on page 22 and To replace the rear body
suspension parts on page 22 .
To replace the
Firmware on page 16 .
To remove and install the body on
To replace the headlights and the
To remove and install the body on
To clean and replace the ventilation fil-
To replace the rear wheels on page
To replace the front wheels on page 31
To replace the rear wheels on page 31 .
To replace the front body suspension
1582 - 001 - 23.12.2020