Ads-B Traffic Menu; Ads-B Status; Tcas Status; Motion Vector - Garmin GTN 650 Series Pilot's Manual Upgrade Supplement

4.2

ADS-B Traffic Menu

The Traffic Menu allows control of the traffic information display.
Select TCAS Status:
Operate and Standby
Select ADS-B Status:
Off, Surface, or
Airborne
Select Motion Vector:
Absolute, Relative, Off
4.2.1

ADS-B Status

ADS-B Status displays the current status of traffic application: Off, Surface,
or Airborne.
Touch the ADS-B Status key to toggle the ADS-B Status.
4.2.2

TCAS Status

This shows the current status of the TCAS system. The modes reported by
the traffic device are "Operate" while in the air and "Standby" while on the
ground. This control allows the pilot to manually select the TCAS Status.
Touch the TCAS Status key to toggle the TCAS Status.
4.2.3

Motion Vector

When Absolute Motion Vectors are selected, the vectors extending from the
traffic targets depict the target reported track and speed over the ground. When
Relative Motion Vectors are selected, the vectors extending from the traffic targets
display how the traffic target is moving relative to your aircraft. These vectors
are calculated using the traffic targets track and ground speed and your aircraft' s
track and ground speed. These two values are combined to depict where the
traffic target is moving purely with respect to your aircraft and give a forecast of
where the traffic target will be, relative to your aircraft, in the near future.
12
GTN 650/750 Series SW V3.00 Upgrade Supplement 190- 01007-05 Rev A
Figure 4-2 ADS-B Traffic Menu
Touch To Perform
Traffic Test
Select Altitude Filter:
Normal, Above, Below,
Unrestricted
Select Vector Duration:
30 sec, 1 min, 2 min,
5 min