Garmin GTN 650 Series Pilot's Manual Upgrade Supplement page 122

Message
REMOTE KEY
STUCK -
Nav remote
transfer key is
stuck.
REMOTE KEY
STUCK -
Remote go around
key is stuck.
REMOTE KEY
STUCK -
TAWS inhibit key is
stuck.
SEARCHING SKY
- Search-the-sky in
progress.
SELECT
FREQUENCY -
Select appropriate
NAV frequency for
approach.
SET COURSE -
Set course on CDI/
HSI to [current
DTK].
116
GTN 650/750 Series SW V3.00 Upgrade Supplement 190- 01007-05 Rev A
Description
The remote nav transfer
(NAV RMT XFR) key/
switch has been in
pressed position for
at least 30 seconds.
This input will now
be ignored. This input
is not available in all
installations.
The TAWS INHIBIT
discrete input has been
in pressed position for
at least 30 seconds.
This input will now
be ignored. This input
is not available in all
installations.
The GTN is searching
the sky for GPS
satellites.
Correct NAV frequency
is not set in the active
NAV frequency for the
approach procedure.
The selected course
on the CDI/HSI does
not match the current
desired track.
Action
Verify the NAV RMT XFR key/
switch is not stuck. Contact dealer
for service if this message persists.
Verify the TAWS INHIBIT key/switch
is not stuck. Contact dealer for
service if this message persists.
Wait 20 minutes for the unit to
complete the cycle or until the
current position is located.
Insert the correct frequency into
the active navigation frequency
window.
Set the CDI/HIS selected course to
the current desired track.