Garmin GTN 650 Series Pilot's Manual Upgrade Supplement page 103

- ILS CDI Capture setting
This data is crossfilled only if crossfill is turned on by the pilot:
• Active navigation (flight plan)
1. While viewing the System Setup page, touch the Crossfill key
to toggle between Enabled and Disabled Crossfill.
2. When Crossfill is about to be enabled, you will be prompted
to note that data will be overwritten in the other unit. Touch
or
OK to enable Crossfill or touch Cancel to return to the System
Setup page without enabling Crossfill.
GTN 650/750 Series SW V3.00 Upgrade Supplement 190- 01007-05 Rev A
Figure 8-1 Confirming Crossfill Selection
Touch OK to Enable
Crossfill With Dual Units
97