Installing And Replacing Drives; Installing In A Server; Identifying The Model; Standards And Safety - HP LTO Ultrium Technical Reference Manual

7 Installing and replacing drives

If you are installing the tape drive on a UNIX system, refer to the UNIX Configuration Guide, Volume
5 of the HP LTO Ultrium Technical Reference Manual.

Installing in a server

Full details of how to install an internal LTO Ultrium tape drive into a server drive bay is given in the
Getting Started Guide.

Identifying the model

The model name is on the front panel and the product and serial numbers are on a label on the top
of the drive.

Standards and safety

Use the drive only in equipment where the suitability of the combination has been determined by an
appropriate certification organization (such as Underwriters Laboratories Inc. or the Canadian
Standards Association in North America, and the British Standards Institution or Verband Deutscher
Elektrotechniker in Europe). Other considerations include the following:
1. A drive must be installed in an enclosure to limit an operator's access to live parts, to provide
system stability, and to give the drive the necessary grounding integrity.
2. A drive must only be supplied by a Safety-Extra-Low-Voltage (secondary) circuit in accordance
with DIN VDE 0805. During incorporation of the equipment, all requirements of DIN VDE 0805
must be observed and obeyed.
NOTE:
The drives are only fused to protect them from excessive currents.
Volume 1: hardware integration 49