HP LTO Ultrium Technical Reference Manual page 92

Code Description
2C40h Buffer manager check buffer CRCs mismatch.
2C41h Buffer manager check CRC passed.
2C50h Illegal SCSI command. The hardware or firmware does not recognize the CDB.
2C51h The SCSI Macro command was aborted because the drive was selected first.
2C52h ATN was pulled by the initiator.
2C53h Initiator did not respond to reselect within the reselect time-out period.
2C54h The internal port interface task queue was empty.
2C55h Too many port interface tasks. There is no room left in the internal port interface task queue.
2C56h Parity error on the SCSI bus.
2C57h Parity error in the mini-buffer.
2C58h Attempted to use an invalid value internally.
2C59h The SCSI FIFO was not empty when attempting to write to it.
2C5Ah Not connected. Attempted to issue SCSI macro target command while not in target mode.
2C5Bh Wrong host. Attempted to communicate with Host X while connected to Host Y.
2C5Ch Wrong bus state. Attempted SCSI macro command while in the incorrect bus phase.
2C5Dh No information on host. This host has not communicated with us previously.
2C5Eh Invalid speed. The saved SCSI bus speed for this host is corrupt.
2C5Fh Invalid SCSI ID, outside the range 0-15.
2C60h The group code in CDB is not supported.
2C61h The host attempted to issue an overlapped command.
Not enough buffer space. The internal requestor asked for more space than was available
2C62h
in the mini-buffer.
2C63h The mini-buffer is non-functional.
2C64h Buffer in use. The internal requestor was denied access to the mini-buffer.
2C65h Status interrupted; the SCSI status phase failed.
2C66h Received an IDE (Initiator Detected Error) message.
2C67h Received an MPE (Message Parity Error) message.
2C68h Received a BDR (Bus Device Reset) message.
2C69h Received an Abort message.
2C6Ah Failed the Media Information check.
92 Drive error codes