HP LTO Ultrium Technical Reference Manual page 82

Code Description
ACI too busy because of comms resync. Used in tracepoints to identify cause of
0443h
AC_BUSY_CMD_REJECTED error.
ACI too busy because upgrading. Used in tracepoints to identify cause of
0444h
AC_BUSY_CMD_REJECTED error.
ACI too busy because out of memory. Used in tracepoints to identify cause of
0445h
AC_BUSY_CMD_REJECTED error.
0446h ACI is resynchronising comms with library after persistant comms failure.
0447h SCSI opcode is not supported in this firmware release.
0448h Internal status indicating an ACI reset is required.
0449h Internal status indicating a full drive reset is required.
044Ah Command contains an invalid Memory ID.
044Bh All Command Control Blocks have been allocated.
044Ch The returned or referenced Command Control Block is invalid.
044Dh Response Time-out — command aborted and response sent.
044Eh Response Time-out — response sent but command allowed to continue.
044Fh Response Time-out — ACI failed to send response within the Response Period.
ACI too busy because the CCB queue is full. Used in tracepoints to identify the cause
0450h
of AC_BUSY_CMD_REJECTED error.
ACI command contains the sequence number of the previous command. The command
0451h
is ignored.
Internal status indicating a slow ACI command being executed before Drive Ready
0452h
event.
0453h Failed to transmit ACK/NAK within the Packet Acknowledgement period.
0454h Internal status indicating a direct ACI command rather than a fast or slow one.
ACI too busy for a direct command. Used in tracepoints to identify cause of
0455h
AC_BUSY_CMD_REJECTED error.
0456h Cannot perform operation because the SCSI burst size is zero or unknown.
0457h Command not supported because the primary interface has not been enabled.
0458h Unable to get a new task object.
0459h An ADI frame has been received while one or more ACI commands are outstanding.
045Ah An SOF was received in ACI Mode which was not a valid frame.
The SSC device has not requested the amount of data supplied with the ACI SCSI
045Bh
command.
045Ch The specified automation port is not supported.
82 Drive error codes