HP LTO Ultrium Technical Reference Manual page 128

Error Description
The thread operation is being retried because the pin detect sensor indicates parked when
7686h
not parked.
7687h The threading recovery could not get the tape stopped in a reasonable time period.
7688h Timed out waiting for a regrab to complete before threading.
7689h Timed out trying to read the media manufacturer's information.
768Ah A faulty LP sensor has made it necessary to detect pin parking via FRM stall.
768Bh Attempt to park failed. An LP sensor was most likely asserted when it should not have been.
768Ch A VI cal was necessary to recover a DSP seek command failure. (This is a recovery algorithm.)
768Dh The FRM driver required a reset and was restarted. This is not a fault.
768Eh The BRM Driver required a reset and was restarted. This is not a fault.
768Fh The reel motor flex continuity check failed, the line is stuck high.
7690h The reel motor flex continuity check failed, the line is stuck low.
7691h Unable to read the media manufacturers information from the LPOS bit stream.
7692h A full eject was invoked as part of a load fault recovery.
7693h Gently nudged grabber in order to help park leader pin. Information only, not a fault.
7694h Leader pin may have come ungrabbed. Regrabbing pin.
7695h A cartridge load as part of init failed.
7696h A special recovery to try to free a stuck LP sensor is in progress.
7697h The recovery effort to try to free a stuck LP sensor failed.
7698h The BRM over rotated during leader block demate in recover tape. Info only.
7699h The front reel motor DAC offset is too large or too small.
769Ah The back reel motor DAC offset is too large or too small.
769Bh A forced eject command was invoked. This is not a fault.
769Ch The LPOS lock-up process 1 produced a value that does not pass the basic sanity check.
769Dh The LPOS lock-up process 2 produced a value that does not pass the basic sanity check.
The removing slack operation timed out while trying to determine the best direction for recov-
769Eh
ery.
769Fh The radii estimation process in recover tape yielded a negative result.
76A0h Unable to send a DspSetGen command.
Failed to complete a SetGen command.
76A1h
76A2h Empty Dsp interrupt.
128 Drive error codes