Siemens SITRANS TH100 Operating Instructions Manual page 134

Parameter assignment
9.1 Overview of parameters and functions
Current output
Set current output
Set saturation limits
Loop test
Application
Select unit
Set the linearization table (60 break‐
points)
Set the spline curve (40 breakpoints)
Change Callendar-Van Dusen coeffi‐
cients
Calibration
One-point calibration
Two-point calibration
Identification
Read and configure identification data of
your device
Maintenance and diagnostics
Set fault current for input and output
Set fault current for sensor error detec‐
tion
Set fault current for drift detection
Display of the diagnostics
Limit monitoring and event counter
134
SIMATIC PDM
"Settings >
Current output" parameter group
"Settings >
Current output" parameter group
Menu command "Device >
Loop test"
SIMATIC PDM
"Settings >
Sensor settings" parameter group
"Settings >
Sensor settings" parameter group
"Settings >
Sensor settings" parameter group
"Settings >
Sensor settings" parameter group
SIMATIC PDM
Menu command "Maintenance > Calibra‐
tion"
Menu command "Maintenance > Calibra‐
tion"
SIMATIC PDM
"Identification" parameter group
SIMATIC PDM
"Maintenance and diagnostics > Measur‐
ing range check mode" parameter group
"Maintenance and diagnostics > Error
detection" parameter group
"Maintenance and diagnostics > Drift de‐
tection" parameter group
Menu command "Diagnostics > Diagnos‐
tics"
Menu command "Diagnostics > Device
status"
SITRANS TH100/TH320/TH420/TR320/TR420/TF320/TF420 with 4 to 20 mA/HART
Device with display
(local operation)
-
-
Loop test [13] (Page 150)
Device with display
(local operation)
Unit [08] (Page 147)
-
-
-
Device with display
(local operation)
One-point calibration input 1 [14]
(Page 152) /
One-point calibration input 2 [15]
(Page 152)
-
Device with display
(local operation)
-
Device with display
(local operation)
-
-
-
-
-
Operating Instructions, 05/2020, A5E41864807-AB