Replace The Gas Grill Orifice-If Equipped With Open-Grate Style Grill - Thermador PLPKIT Conversion Instructions

• Each orifice is stamped "107" (for 1.07mm orifice
diameter) as shown.
Replace the Gas Grill Orifice—if equipped
with Open-Grate Style Grill
This style grill is an open-top design that can be identified
by its "U" shaped burner tube and corrugated stainless-
steel radiant, as shown in the exploded view.
WARNING
The grill must be assembled as shown. The drip
tray heat shields must be in place, and the
burner must be properly positioned relative to
the gas supply. Incorrect assembly of the grill
may result in unsafe or hazardous conditions
during operation.
English 6
• Remove the Grill Grate, Radiant, and Grill Burner from
the Grill Can Assembly.
• Pull back the metal lever at the front of the Grill Burner
to release it, and then remove the Grill Burner.
• Use a 1/2" deep-well socket to remove the Grill hood
orifice and replace with the 1.20mm LP hood orifice
supplied in this kit.
• Pre-adjust the burner's air shutter to approximately
75% closed (approximately 0.20" opening) position and
re-tighten screw(s) using a 1/4" nut driver or wrench.
• Re-insert the venturi end of the Grill Burner into the two
slots at the back of the Grill Can Assembly. Then rotate
the other end of the burner into position and lock the
tab on the front of the burner into the slot in the Heat
Deflector.
• Re-install the stainless steel Radiant onto the two studs
on each end of the Grill Can Assembly.