Installing And Removing A Hard Disk In Bay 5 - IBM Aptiva Hardware Handbook

Installing and removing a hard disk in bay 5

Bay 5 can hold a 3.5-inch slim hard disk. For hard disk removal, reverse these steps.
1.
To attach the mounting bracket, align the screw
holes and insert the two screws.
Hard Disk
(Front View)
The drive is drawn in this position to show
bracket attachment. Once the bracket is installed
note: on the drive, rotate the drive 180 degrees so that
the front of the drive faces the front of the system
unit.
122 Installing and removing a hard disk in bay 5
Drive
Connectors
Mounting
Bracket
2.
Insert the hard disk (with the bracket attached) into
the bay. Align the screw holes and insert the four
screws. Connect the power and signal cables. (To
ensure that your hard drive functions properly,
read "Installing additional drives" on page 116
before connecting the cables.)
Drive
Power Cable
Signal Cable
(Back View)