IBM Aptiva Hardware Handbook page 113

Installing and removing a drive in bay 2 (continued)
3.
Drive cable connections
Connect all drive cables.
Drive
Signal Cable
If you are adding a diskette, tape, or CD-ROM drive
that attaches to the Diskette connector, make sure the
signal cable you plug into the drive is attached to the
note:
Diskette connector on the system board. To identify
the Diskette connector, see "Identifying parts of the
system board" on page 127.
Power Cable
(Back View)
4.
Left bracket replacement and drive cable
connections
For instructions on replacing the left bracket and
connecting the drive cables for any drive that may
be attached to the left bracket, see page 99.
Installing and removing a drive in bay 2 101