IBM Aptiva Hardware Handbook page 74

Table 10: Error codes, descriptions, and corrective actions (Continued)
Error Code Description
162 Configuration Error
Configuration Change Has
Occurred
163 Date and Time Incorrect
Notes:
1. An X shown as part of the error code in this table represents any number between 0 and 9.
2. If any of these errors continue after taking the actions listed, check your A Guide to HelpWare and All the Extras folder for
information on obtaining service.
62 Error codes, descriptions, and corrective actions
Here's what to do:
• If you are using Rapid Resume, complete the following steps:
- If you have not changed your hardware (installed or removed an option),
check your A Guide to HelpWare and All the Extras folder for information
on obtaining service.
Note: Any work that you did not save before the computer was turned off
cannot be retrieved.
- If you have changed your hardware (installed or removed an option), press
the on/off button on the system unit to turn it off. Return the hardware to its
previous configuration, wait 10 seconds, and then turn the system unit on
again. If the error does not reoccur, save any work that you want to keep
and reinstall your hardware. If the error occurs again, check your A Guide
to HelpWare and All the Extras folder for information on obtaining service.
• If you are not using Rapid Resume:
- Press Enter while the error message is displayed to start the Setup Utility.
Look through the Setup Utility and verify that the options with
them were supposed to change. If so, press the Esc key and then press
Enter to save the new settings. Then exit the Setup Utility. For more
information on using the Setup Utility, see page 69. If options changed that
were not supposed to, check your A Guide to HelpWare and All the Extras
folder for information on obtaining service.
The clock module on the system board may not be set correctly. To set the
correct date and time, press Enter while the error message is displayed to
enter the Setup Utility. For instructions on using the Setup Utility, see page 69.
next to