Frame Assembly - Weider WESY29510 User Manual

Frame Assembly

1. Before beginning assembly, be sure that you
have read and understand the information in
the box on page 5.
Press three 2" Square Inner Caps (55) into the
ends of the Stabilizer (1) and the Base (2). Insert
two 5/16" x 2 3/4" Carriage Bolts (66) up through
the Stabilizer. Insert two 5/16" x 2 1/2" Carriage
Bolts (65) up through the Base.
The Punching Bag (not shown) can be assembled
on either side of the weight system. Orient the
Stabilizer (1) so that the indicated hole is on the
side of weight system that you want the Punching
Bag to be on. Note: The assembly steps in this
manual show the Punching Bag assembled on
the right side of the weight system.
Attach the Stabilizer (1) to the Base (2) with the
Base Support Plate (3), two 5/16" x 2 3/4" Bolts
(73), and two 5/16" Nylon Locknuts (83). Do not
tighten the Nylon Locknuts yet.
2. Slide the Rear Upright (5) onto the 5/16" x 2 3/4"
Carriage Bolts (66) in the Stabilizer (1). The high
side of the bracket on the Rear Upright must
be on the side shown. Hand tighten a 5/16"
Nylon Locknut (83) onto each Carriage Bolt.
Attach the Rear Upright (5) to the Base (2) with
the Base Support Plate (3), two 5/16" x 2 3/4"
Bolts (73), and two 5/16" Nylon Locknuts (83).
Tighten the 5/16" Nylon Locknuts (83) used in
steps 1 and 2.
Set two Weight Bumpers (28) over the indicated
holes in the bracket on the Base (2). Insert the
two Weight Guides (9) into the holes in the brack-
et. Be sure that the holes in the Weight Guides
are at the top, as shown.
1
Hole
2
65
55
2
Holes
28
2
6
55
1
3
83
83
66
High Side
of Bracket
9
5
83
3
73
66
1
83
73
55