Weider WESY29510 User Manual page 11

17. Route the Long Cable (41) around a "V"-Pulley
(46). Attach the Pulley and a Long Cable Trap
(43) to the bracket on the Left Arm (11) with a 3/8"
x 2 1/2" Bolt (79) and a 3/8" Nylon Locknut (84).
Be sure that the Cable is in the groove of the
Pulley and that the Cable Trap is positioned to
hold the Cable in place.
18. Route the Long Cable (41) around a "V"-Pulley
(46). Attach the Pulley and a Long Cable Trap
(43) to the bracket on the Right Arm (12) with a
3/8" x 2 1/2" Bolt (79) and a 3/8" Nylon Locknut
(84). Be sure that the Cable is in the groove of
the Pulley and that the Cable Trap is posi-
tioned to hold the Cable in place.
19. Route the Long Cable (41) around the 3 1/2"
Pulley (45) attached to the Pulley Bracket (51).
Be sure that the Cable is in the groove of the
Pulley and that the Cable Trap (44) is turned
to hold the Cable in place. Tighten the 3/8"
Nylon Locknut (84).
Be sure that the 5/16" x 5" Bolt (not shown) is
properly tightened and that the Pulley Bracket
(51) can move freely.
20. Attach a 3 1/2" Pulley (45) and a Cable Trap (44)
to the indicated hole in the Long "U"-Bracket (50)
with a 3/8" x 2" Bolt (74) and a 3/8" Nylon
Locknut (84). Be sure that the Cable Trap is
inside the "U"-Bracket. Note: This may come
pre-assembled.
Route the Long Cable (41) between the 3 1/2"
Pulley (45) and the Cable Trap (44). Be sure that
the Cable is in the groove of the Pulley and
that the Cable and Pulley move smoothly.
17
Bracket
41
84
18
79
43
46
Bracket
12
41
84
19
20
11
79
43
46
11
51
44
45
41
84
41
45
44
74
50
84