Frame Assembly - Weider club 4870 WESY3906.0 User Manual

Frame Assembly

1.
Before beginning assembly, make sure you
understand the information in the box on
the previous page. For help identifying
small parts, use the PART IDENTIFICATION
CHART on pages 5 and 6 of this manual.
Insert four M10 x 80mm Carriage Bolts (88) up
through the Right Base (1). Place a piece of tape
over the Bolt heads to hold the Carriage Bolts in
place.
See the inset drawing. Insert two M10 x 80mm
Carriage Bolts (88) up through the Left Base (2).
Place a piece of tape over the Bolt heads to hold
the Carriage Bolts in place.
2. Attach the Center Base (5) to the Right and Left
Bases (1, 2) with four M10 x 70mm Bolts (57),
four M10 Washers (108), and two M10 Nylon
Locknuts (84). Do not tighten the Bolts yet.
3. Orient the Center Upright (9) so the 2" Square
Inner Cap (51) is in the position shown. Attach
the Center Upright to the Right and Left Bases (1,
2) with four M10 x 70mm Bolts (57), four M10
Washers (108), and two M10 Nylon Locknuts
(84). Do not tighten the Bolts yet.
1
1
88
2
57
108
1
3
57
108
84
1
8
88
2
88
84
84
5
108
2
51
9
57
108
108
84
2
57