Weider club 4870 WESY3906.0 User Manual page 19

38. Wrap the Low Cable (70) under a Pulley (43).
Attach the Pulley, an M10 Washer (108), and two
Half Guards (46) to the Right Base (1) with an
M10 x 45mm Bolt (95) and an M10 Nylon Locknut
(84). Make sure the Half Guards are oriented
as shown.
39. Route the Low Cable (70) over a Pulley (43) and
through the Center Upright (9). Attach the Pulley
inside the Center Upright with an M10 x 65mm
Bolt (87), two M10 Washers (108), two 1/2"
Bushings (68), and an M10 Nylon Locknut (84).
40. Wrap the Low Cable (70) under a Pulley (43).
Attach the Pulley, a Cable Trap (48), and a Guard
(45) to the Small Pulley Plate (50) with an M10 x
50mm Bolt (105) and an M10 Nylon Locknut (84).
Make sure that the Cable Trap is oriented to
hold the Cable in the groove of the Pulley.
41. Wrap the Low Cable (70) over a Pulley (43).
Attach the Pulley to the Left Top Frame (4) with
an M10 x 45mm Bolt (95) and an M10 Nylon
Locknut (84).
38
84
46
108
39
84
108
68
43
70
40
105 50
41
84
19
70
43
1
46
95
108
68
87
9
84
70
48 45
43
4
43
70
95