Table of Contents
Advertisement
58. Attach the Curl Pad (38) to the Curl Post (16) with
two M6 x 16mm Screws (99).
59. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on page 25.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly
over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If
the cables are not properly installed, they may be damaged when heavy weight is used. See the
CABLE DIAGRAM on page 28 of this manual for proper cable routing. If there is any slack in the
cables, you will need to remove the slack by tightening the cables (see page 26).
58
38
24
16
99
Hide quick links:
Advertisement
Table of Contents
