Advertisement
Installing the Cisco NCS 4216
Connecting T1/E1 cables
Connecting Cables to the Patch Panel
Figure 21: Interface Module with the Connector
Figure 22: Patch Panel with the Connector
If you are connecting two T1/E1 interfaces to each other, you must cable both interfaces' patch panels together
using a T1 straight-through shielded cables. If both T1/E1 interfaces are connected to their patch panels in a
different configuration, use a T1 straight-through cable (standard RJ48C patch cable) to connect the patch
panels.
Cisco NCS 4216 Hardware Installation Guide
59
Advertisement
