Advertisement
Connecting to the Auxiliary Port
SUMMARY STEPS
1. Run the setup.exe for Windows 32-bit or setup(x64).exe for Windows-64bit. Click Next.
2. The InstallShield Wizard for Cisco Virtual Com appears. Click Next.
3. When the Program Maintenance window appears, select the Remove radio button. Click Next.
4. When the Remove the Program window appears, click Remove.
5. When the InstallShield Wizard Completed window appears click Finish.
DETAILED STEPS
Step 1
Run the setup.exe for Windows 32-bit or setup(x64).exe for Windows-64bit. Click Next.
Step 2
The InstallShield Wizard for Cisco Virtual Com appears. Click Next.
Step 3
When the Program Maintenance window appears, select the Remove radio button. Click Next.
Step 4
When the Remove the Program window appears, click Remove.
Note
If a User Account Control warning appears, click "Allow - I trust this program..." to proceed.
Step 5
When the InstallShield Wizard Completed window appears click Finish.
What to Do Next
post
Note
Connecting to the Auxiliary Port
When a modem is connected to the auxiliary port, a remote user can dial in to the router and configure it. Use
a light blue console cable and the DB-9-to-DB-25 connector adapter.
Note
The console cable and DB-9-to-DB-25 connector are not included with the Cisco NCS 4216; they are
ordered separately.
To connect a modem to the router, follow these steps:
SUMMARY STEPS
1. Connect the RJ45 end of the adapter cable to the black AUX port on the router, as shown in the figure
below.
2. Connect the DB-9 end of the console cable to the DB-9 end of the modem adapter.
3. Connect the DB-25 end of the modem adapter to the modem.
4. Make sure that your modem and the router auxiliary port are configured for the same transmission speed
(up to 115200 bps is supported) and for mode control with data carrier detect (DCD) and data terminal
ready (DTR) operations.
Cisco NCS 4216 Hardware Installation Guide
48
Installing the Cisco NCS 4216
Advertisement
