Advertisement
Installing the Cisco NCS 4216
Connecting a USB Flash Device
To connect a USB flash device to the Cisco NCS 4216, insert the memory stick in the USB port labeled MEM.
The Flash memory module can be inserted in only one way, and can be inserted or removed regardless of
whether the router is powered up or not.
The following figure shows the USB port connector on the Cisco NCS 4216.
Figure 18: Cisco NCS 4216 Flash Token Memory Stick
Removing a USB Flash Device
To remove and then replace a USB flash token memory stick from a Cisco NCS 4216, follow these steps:
SUMMARY STEPS
1. Pull the memory stick from the USB port.
2. To replace a Cisco USB Flash memory stick, simply insert the module into the USB port labeled MEM
as shown in the Cisco NCS 4216 Flash Token Memory Stick figure. The Flash memory module can be
inserted in only one way, and can be inserted or removed regardless of whether the router is powered up
or not.
DETAILED STEPS
Step 1
Pull the memory stick from the USB port.
Step 2
To replace a Cisco USB Flash memory stick, simply insert the module into the USB port labeled MEM as shown in the
Cisco NCS 4216 Flash Token Memory Stick figure. The Flash memory module can be inserted in only one way, and can
be inserted or removed regardless of whether the router is powered up or not.
You can insert or remove the memory stick whether the router is powered on or
Note
not.
This completes the USB Flash memory installation procedure.
Connecting a USB Flash Device
Cisco NCS 4216 Hardware Installation Guide
51
Advertisement
