Advertisement
Installing the Cisco NCS 4216 Door
SUMMARY STEPS
1. Align the left door bracket screw holes against the shelf screw holes.
2. Insert the fasteners provided along with the packaging (three screws on the side and two screws on the
bottom of the door bracket) and tighten them to a torque value of 11.5 in-lb (1.3 N-m).
3. Place a safety washer on the front bottom of the door bracket and fasten it with a fastener.
4. Repeat steps 1 and 2 for the door bracket on the opposite side.
5. Pull the top hinge pin down on the door.
6. Align the door hinges with the bracket hinges.
7. Slide the bottom hinge pin into the bracket hinge and move the top hinge pin in the upward direction.
8. Connect the other end of the ground strap cable to a grounding point on the door bracket using a fastener.
DETAILED STEPS
Step 1
Align the left door bracket screw holes against the shelf screw holes.
Step 2
Insert the fasteners provided along with the packaging (three screws on the side and two screws on the bottom of the
door bracket) and tighten them to a torque value of 11.5 in-lb (1.3 N-m).
Step 3
Place a safety washer on the front bottom of the door bracket and fasten it with a fastener.
Step 4
Repeat steps 1 and 2 for the door bracket on the opposite side.
Step 5
Pull the top hinge pin down on the door.
The bottom hinge pin is
Note
fixed.
Step 6
Align the door hinges with the bracket hinges.
Step 7
Slide the bottom hinge pin into the bracket hinge and move the top hinge pin in the upward direction.
Note
The ground strap cable is pre-installed on the
door.
Step 8
Connect the other end of the ground strap cable to a grounding point on the door bracket using a fastener.
Opening and Removing the Door of the NCS 4216 Shelf
This procedure opens and removes the door of the NCS 4216 shelf.
The NCS 4216 shelf has an ESD plug input and is shipped with an ESD wrist strap. The ESD plug input
Note
is located on the outside of the shelf on the right side. It is labeled "ESD" on the top and bottom. Always
wear an ESD wrist strap and connect the strap to the ESD plug when working on the NCS shelf.
To open and remove the door of the NCS 4216 router, follow the steps below:
Cisco NCS 4216 Hardware Installation Guide
10
Installing the Cisco NCS 4216
Advertisement
