Cisco NCS 4216 Installing Instruction page 37

Hide thumbs Also See for NCS 4216:

Installing the Cisco NCS 4216

• Positive (+) lead wire (right)

Figure 15: DC Power Supply with Lead Wires

Step 4

Insert the exposed wire of one of the three DC-input power source wires into the terminal block plug. Make sure that

you cannot see any wire lead. Only wire with insulation should extend from the terminal block.

Do not overtorque the plug captive screws of the terminal block. The recommended maximum torque is from

Caution

4.425 in.-lb (.5 N-m) to 5.310 in-lb (.6 N-m).

Positive (+) lead wire

Installing the DC Power Supply

Cisco NCS 4216 Hardware Installation Guide

Negative (-) lead wire

Table of Contents