Advertisement
Installing the Fan Tray
DETAILED STEPS
Step 1
Orient the fan tray so that the captive screws are on the left side of the fan tray's front panel. The following figure shows
how to orient the fan tray.
Figure 7: Installing the Fan Tray
Step 2
Guide the fan tray into the chassis until it is fully seated.
The fans are exposed on the left side of the fan tray. Keep your fingers, clothing, and jewelry away from the
Caution
fans. Always handle the fan tray by the handle.
When installing the cabling to the RSPs, we recommend that you leave a service loop of extra cabling sufficient
Note
to allow for fan tray removal.
Step 3
Secure the fan tray to the chassis using the attached captive installation screws. The recommended maximum torque is
5.5 in.-lb (.62 N-m).
This completes the procedure for installing or replacing the fan tray in a Cisco NCS 4216.
Cisco NCS 4216 Hardware Installation Guide
16
Installing the Cisco NCS 4216
Advertisement
