Table of Contents
Advertisement
2. GENERAL PRODUCT GUIDELINES
2.1
APPLICATION AND SIZING
These heaters are designed to provide a central source of heat for a ducted central heating system.
The heaters should not be installed downstream from an air washer, an evaporative cooler or refrigerative cooling
system. Nor are they designed to be installed on a marine craft, houseboat, or any similar environment.
The heaters must be installed in accordance with these instructions and related regulations, codes, standards, and
authorities. These include but may not be limited to:
•
AS/NZS 3000 - Electrical Installations
•
AS/NZS 5601 - Gas Installations
•
AS 4254 - Ductwork for air-handling systems in buildings
•
HB 276 - A Guide to Good Practice
•
AS/NZS 5141 - Residential Climate Control Systems
•
Local Gas and Electricity Authority Codes
Note: The manufacturer assumes no responsibility for equipment installed in violation of any code, regulations and these installation
instructions.
It is recommended the Product Sizing Guide is followed in estimating heating requirements and for system design
that will result in efficient installation and provide a higher level of comfort and economical operation.
For the hourly input and the gas type to be used, refer to the appliance data label located inside the service
compartment or the Technical Specifications at the rear of this manual.
Note: All installations should only be carried out by a qualified tradesperson. Installations at altitudes above 1000m above sea level
may require main burner injector upgrading. Please contact the Customer Service Centre for advice.
2.2
INSPECTION
This appliance has been inspected and tested at the time of manufacture and packaging and released for
transportation without known damage. Upon receipt, inspect the exterior for evidence of rough handling in shipment.
Ensure that the appliance is labelled correctly for the gas to which it is intended to be connected. If a discrepancy or
damage to the appliance is identified DO NOT install the appliance and report findings back to supplier.
2.3
UNPACKING THE HEATER
Some heaters are supplied on a pallet with a plastic sleeve. To unpack:
•
Cut and remove the external plastic packaging and dispose of thoughtfully.
•
Remove heater from pallet (if supplied).
2.4
UNLOADING OR LIFTING THE HEATER
When unloading or lifting the heater, ensure lifting equipment is in good operating condition and capable of lifting
the total load. Be sure there is a clear area to place the heater down, which is within reach of the lifting equipment.
Note: Do not use the lifting handles provided to lift the heater above head height. If fitting the heater to elevated heights such as a
roof, use suitable lifting equipment.
Brivis
•
Product Sizing Guide
•
Local Building Regulations
•
Environment Authorities
•
Building Code of Australia (BCA)
8
Ducted Gas Heater IM
Hide quick links:
Advertisement
Table of Contents
