Page 1
• Manufacturer’s Installation Instructions • Local Regulations and Municipal Building Codes This appliance must be serviced and repaired by an Authorised Person. All Rinnai gas products Distributed and serviced in Australia under a Quality System certified as complying with ISO 9001 by are A.G.A.
TABLE OF CONTENTS RINNAI WARRANTY ....................... ii ABOUT YOUR PORTABLE CONVECTOR HEATER............. 1 GENERAL DESIGN LAYOUT......................1 NAVIGATING THE CONTROL PANEL ..................... 2 NAVIGATING THE REMOTE CONTROL..................3 FEATURES ..........................4 IMPORTANT POINTS......................5 INSTALLATION ........................7 UNPACKING THE APPLIANCE ......................7 WHAT’S IN THE BOX........................
Rinnai heating products are warranted by Rinnai for the cost of labour and components in the event of defects arising from faulty materials and/or workmanship in accordance with the Warranty Terms, Conditions and Exclusions stated in this document.
ENDURO Control panel Gas inlet connection ON / OFF button Filter 1 Stops and operates the heater. Filter 2 Remote control receiver window Thermistor Louvre, warm air discharge 240v power cord Carry handle(s) Power cord tidy Rinnai Australia Operation Manual...
Operates Timer programme 2. Operates the Off Timer (60 minutes). Timer 2 indicator Off timer indicator Indicates Timer 2 is in operation. Indicates heater is in Off Timer mode. Override button Operates the manual Override function. Rinnai Australia Operation Manual...
Avoid leaving the remote control in direct sunlight and do not place the remote control close to the louvres of the heater. Avoid getting the remote control wet, or dropping it. Rinnai Australia Operation Manual...
The heater will automatically come on and then remain on until you manually turn it off. OFF TIMER This feature allows you to program the heater to operate for a period of one hour before it automatically turns off. Rinnai Australia Operation Manual...
DO NOT spray aerosols near this heater while it is in use. Most aerosols contain butane gas which can be a fire hazard if used near this heater when it is in use. Use of aerosols, paint, polishes etc. whilst this heater is in use may also cause unpleasant smells. Rinnai Australia Operation Manual...
Page 10
When the heater is operated for the first time or after long periods of non use a slight odour may be emitted, this is normal. However if odours persist switch off the appliance and contact Rinnai. During peak operating periods the filters should be cleaned weekly, however if the Filter warning indicator illuminates, turn off the appliance immediately and clean filters before further use.
“VENTILATION” on page 8 and the warning label located on the appliance. For further information regarding room ventilation contact Rinnai or your local gas authority. • DO NOT USE THIS APPLIANCE TO HEAT A BEDROOM, BATHROOM, TOILET, COMBINED LIVING/SLEEPING AREA OR SAUNA.
To determine if the intended room meets the minimum size requirements simply multiply the Height x Width x Depth. For example if the room dimensions are Length 5.3 metres, Width 5.0 metres and Height 2.4 metres then the volume would be 63.6 m³ and suitable for use with an Avenger 25. L e n g t h A Rinnai VENT kit provides 2 x 250cm²...
Rooms may not arrive at the "SET" temperature due to the size and construction of the room, location of the appliance or external temperatures. NOTE If the appliance does not ignite then the pre-set temperature may already be higher than the actual room temperature. Rinnai Australia Operation Manual...
Economy mode. To cancel Economy mode press the Economy button and the Economy indicator will go out to show that the economy mode has now been cancelled. Rinnai Australia Operation Manual...
To lock in the new Timer 1 on and off timer program and to exit the Clock setting and Timer programming mode without altering the Timer 2 settings press the Set Times NOTE button three times. Rinnai Australia Operation Manual...
To cancel timer(s) operation press the associated timer button(s). The indicator will go out to signify that the heater is now operating under manual control. Rinnai Australia Operation Manual...
Off time setting is reached. If the ON/OFF button or the OFF button on the remote control are pressed the heater will be turned off and the timer programs will not operate. NOTE Rinnai Australia Operation Manual...
The Off Timer and On Timers work independently of each other. However, if both timers are operating and the Delay On time period is 30 minutes, the Delay Off Timer will override the Delay On Timer. Rinnai Australia Operation Manual...
If the heater is knocked over, the tilt switch will cut the gas supply. The fan keeps cycling. Power failure In the event of a power failure or power cut, the gas valves will automatically close. Rinnai Australia Operation Manual...
If the power supply cord or any other component of the heater are damaged, they must be replaced by Rinnai or a suitably qualified person. Any service or repair work should only be carried out by an authorised person. Rinnai has service and spare parts departments nationally see back cover for contact details.
CARE AND MAINTENANCE TROUBLE SHOOTING CHECKLIST Use the following chart to help determine whether a service call is required, however if you are unsure about the way your heater is operating, contact Rinnai or your local agent. Fault Condition Possible Remedy...
*Cost of a local call Higher from mobile or public phones. Fax: (03) 9271 6622 U???-???? Rinnai has a Service and Spare Parts network with personnel who are fully trained BARCODE and equipped to give the best service on your Rinnai appliance. If your appliance Printed in Japan YYYY.MM...