Precor M9.3s Owner's Manual page 9

Secure top two
Photo 3
bolts.
5/16" hex key
7. Remove the foam blocks and set the base of the treadmill flat on the floor.
8. Loosen the top two bolts one full turn. This will allow the control panel
9. Firmly tighten all four bolts with the 5/16" hex key and insert the white hole
10. To mount the upper handrails, use a flathead screwdriver to remove the
11. Place the upper end of the RIGHT handrail into the hole in the right column
12. Replace the 1" bolt by feeding it through the hole in the handrail and into
assembly to shift and rest securely on the running bed assembly. You may
need to rock the control panel assembly gently so it will seat properly on
the four bolts. The lower edges of the control panel assembly should be
flush with the base of the treadmill.
plugs into the mounting bolt access holes.
1" bolt from the RIGHT side of the upper control panel assembly.
Note: LEFT and RIGHT are determined while standing behind the tread-
mill, facing toward the front of the machine.
of the control panel assembly. Insert the handrail over the steel bar with the
threaded hole. (See Photo 4).
the threaded hole in the steel bar. To align the holes, you may have to
rotate the center bar located under the control panel. Using the flathead
screwdriver, tighten the bolt until it feels snug, but do not overtighten.
page 9