Precor M9.3s Owner's Manual page 10

Photo 4
Photo 5
page 10
Insert handlebars
into the control
panel assembly.
13. Slide the lower end of the RIGHT handrail onto the black fitting located on
the side of the frame. (See Photo 5). Align the hole in the handrail with the
threaded hole in the fitting. If the holes do not align, slide the 5/32" hex key
into the threaded hole and turn the fitting so the holes align. Take a
1/4" x 1/2" socket head screw from the hardware kit and hand thread it into
the fitting. Tighten the screw with the 5/32" hex key.
14. To attach the opposite handrail, repeat steps 10 through 13.
Attach
handlebars to
running bed
assembly.
15. Attach the labels provided in the hardware kit over each upper handlebar
bolt.
16. If you need to move the treadmill, ask for assistance from another person.
Roll the treadmill on its front wheels to the new location by lifting the rear
end of the unit.
CAUTION: Do not attempt to bypass the three-prong plug with an
adapter for a non-grounded outlet.
17. Plug the power cord into a grounded 120v household outlet with a dedi-
cated 20 amp circuit breaker.