Table of Contents
Advertisement
Domestic ventilation unit M Flex Air (Plus)
6.3 Vertical installation
The supporting feet are screwed onto the pre-punched cover
sections on the underside of the unit using the panel screws
supplied and are then aligned horizontally and vertically.
1
2
3
4
Fig. 6.4:Unit positioned vertically
Ventilation unit with control unit
1
2
Supporting foot
3
Condensate drain (right-hand unit)
Condensate drain when using the unit in
4
cooled living areas
To cover the visible supporting feed, a base plate for vertical in-
stallation can be ordered as an accessory.
www.glendimplex.de
6.4 Horizontal installation
The supporting feet are screwed onto the pre-punched cover
sections on the desired side of the unit using the panel screws
supplied and are then aligned horizontally and vertically.
Fig. 6.5:Horizontal installation with air duct connections to left (factory de-
fault, right-hand unit)
Fig. 6.6:Horizontal installation with air duct connections to right (converted to
left-hand unit on site)
1
2
3
CAUTION!
When the air duct connections are aligned to the right, the
unit must be converted to a left-hand unit (siehe Kap. 5.3 auf
S. 8)!
For the condensate drain position, see Fig. 6.5 and Fig. 6.6
For horizontal versions, the side panel must first be broken out
at the pre-perforated location.
For use in cooled buildings, a vertically installed unit is prefera-
ble.
To cover the visible supporting feed, a base plate for horizontal
installation can be ordered as an accessory.
DOK4SVxxDEN · FD 9912
Ventilation unit with control unit
Supporting foot
Condensate drain
English
1
2
3
1
2
3
13
Advertisement
Table of Contents
