Answering system
Menu features
System announces
Announcements
Remote access code
Message alert
Announcement only,
record no message
Base ringer
Number of rings
Outgoing announcement
Your answering system is pre-set with an announcements for normal
(answer and record) mode and announcement only mode. If the
phone is set up to record messages, the phone answers calls with
"Hello. Please leave a message after the tone." You can use this
announcement, or replace it with your own.
Record outgoing announcement
1. Press SETUP, the system announces "Announcement. Press PLAY
or press RECORD. To continue set up, press SETUP."
. Press REC/MEMO. After you hear "Record after the tone. Press
STOP when you are done," speak toward the MIC to record an
announcement for up to 90 seconds.
3. The elapsed time (in seconds) is shown in the message window
when recording.
3
Description
Outgoing message to tell callers to leave a message.
Set code to access remotely from a touch tone phone.
Beeps every 10 seconds when there are new messages.
Outgoing message only. No recording of incoming messages.
Turn base ringer on or off.
Change the number of times the system rings before it answers a
call, (, 4, 6 or toll saver).
www.vtechphones.com