Removing The Isolator, Badge, & Door Handle - KitchenAid KUD Series Technical Education

REMOVING THE ISOLATOR, BADGE, & DOOR HANDLE
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug dishwasher or disconnect power.
2. Open the dishwasher drawer.
3. Using a pair of longnosed pliers, pull out
and remove the left and right pins from the
tub. NOTE: Keep the pin web in the verti-
cal position when you reinstall the pin in
the tub.
4. Pull the drawer front down so it is free of
the handle and the top locating slots and
remove the front.
Side Of Tub
Pin
4-3
5. To remove the isolator:
a) Disconnect the two green ground wires
from the inner door panel, and the badge
connector from the isolator connector.
b) Remove the isolator from the front of
the dishwasher.
c) Disconnect the two wire connectors
from the isolator.
Isolator
Connector
(Blue Wires)
Continued on the next page.
Ground Wires
Badge & Isolator
Connectors
Isolator
Connector
(White Wires)