KitchenAid KUD Series Technical Education page 26

Custom Front Panels
1. Prepare the custom front panels to speci-
fications shown below.
2. Mount the handle to the custom panel.
The screws must not extend beyond the
back surface of the panel. (The handle is
customer supplied, and the location is
customer preference.)
Custom Front Panels Dimensions
medallion
cutout area
Top panel
(front view)
medallion
cutout area
Bottom panel
(front view)
Upper and lower panel minimum thickness is 5/8" (16 mm). Panel thickness above 11/16" (18 mm)
can be accommodated but product depth will increase accordingly.
Custom front panel material must be suitable for damp conditions or adequately sealed to withstand
moisture. Using a moisture resistant material can provide additional protection. Taping edges alone
may not provide adequate sealing. For painted panel, paint all rear edges to improve sealing.
9"
(22.9 cm)
23-7/16" (59.5 cm)
9"
(22.9 cm)
23-7/16" (59.5 cm)
3. Measure and mark the vertical centerline
and horizontal position line on the back of
the front panels.
Top Panel -
1-7/16" (36.5 mm)
Bottom panel -
1-3/16" (30.2 mm)
2-5/16"
(5.9 cm)
15-5/8"
(39.7 cm)
5"
(12.7 cm)
1-7/32"
(30.8 mm)
2-1/8"
(5.4 cm)
14"
(35.6 cm)
NOTE: Do not cut beyond outline of
medallion cutout shown above.
5"
(12.7 cm)
Rout a 1/4" (6 mm) radius around
back side of medallion cutout.
2-16
mark horizontal line
mark centerline
end may be round
or squared off
1-9/32"
(32.6 mm)
max.
1/4"
(6.4 mm)
1-13/64"
(30.6 mm)
2-13/32"
(60.8 mm)
Medallion cutout
(front of panel)