KitchenAid KUD Series Technical Education page 27

4. Feed the wires of the medallion through
the front of the custom front panel and
push the medallion into the prepared me-
dallion hole.
5. Lay the custom front panel face down on
a protective covering.
6. Remove the pin on both sides of the dish-
washer drawer with a pair of needlenose
pliers. Pull the pin straight out.
pin
7. Gently pull the bottom of the metal plate
away from the dishwasher, and then pull
down.
8. Lay the custom front panel face down.
9. Feed the medallion wires through the wire
opening in the metal plate. Lay the metal
plate on the back of the custom front panel.
front
panel
wire
opening
metal
plate
2-17
10. Align the centerline marked on the custom
panel with the diamond shape and notch
in the metal plate to center the metal plate
horizontally. Align the horizontal line with
the top of the metal plate.
centerline
11. Fasten the metal plate with the three inner
holes on the outside of the bracket on
each side to the front panel with screws
provided.
three
inner holes
12. Connect the medallion connector to the
dishwasher connector.
13. Fit the metal plate tabs to the notches and
slots on the dishwasher and gently pull up
to lock in place.
horizontal line
top of plate