KitchenAid KUD Series Technical Education page 53

8. To remove the hall sensor:
a) Disconnect the wire connector at P701.
b) Unclip the locking tab from the hall
sensor board and lift the board up and
off the motor/heater housing.
Hall Sensor
P701
Wire Connector
Lift Sensor
9. To remove the wash and drain motor
and heater element assembly:
a) Remove the hall sensor (see step 8).
b) Disconnect the green wire from the
ground terminal (see the photo at the
top of the right column).
c) Remove the drain and fill hoses, and
the electrical wires from the locking ring
clips.
d) Disconnect the heater element wiring
connector.
Locking Tab
4-11
Ground Wire
Heater
Element
Electrical
Connector
Wires
e) Unclip the two locking arms on the motor
housing from the end of the drain hose,
and pull the hose out of the housing.
Continued on the next page.
Drain & Fill
Hoses
Locking Ring
Drain Hose
Motor Housing
W / Locking Arms