KitchenAid KUD Series Technical Education page 13

CABINET DIMENSIONS / REQUIREMENTS
22-7/8"
(58.0 cm)
moisture
protection tape
32-5/16" - 34-5/8"
(82.0 cm - 88.0 cm)
Utility hole:
1-1/2" (3.8 cm) dia.
hole, either side –
immediately
adjacent to corner
23-5/8" *
(60.0 cm)
4"
(10 cm)
tape
1/2" (12.7 mm)
from front of
counter top
It is recommended that wood cabinetry surrounding
the dishwasher be sealed with an oil based paint or
moisture-proof polyurethane to prevent possible
damage from heat and humidity.
The utility hole must be located as shown. If the hole
is not located as shown, the hoses will prevent the
dishwasher from being pushed back all the way into
the cavity. Make sure the edges of the utility hole are
smooth or covered. If the utility hole is through a
metal cabinet, the hole must be protected with the
edge protector provided.
*IMPORTANT: Custom wood door panels, if used,
may be wider than the dishwasher to match
surrounding cabinets. The 23-5/8" (60.0 cm) must be
increased so that there is a 1/4" (6.4 mm) clearance
between the cabinet side and panel edge.
For corner installation, there must be a 1/2" (12.7 mm)
space between the adjacent cabinet doors (i.e. door
knobs) and open dishwasher drawer.
2-3
typical installation
counter top
moisture
protection tape