KitchenAid KUD Series Technical Education page 19

If the bottom drawer was rotated, rotate
the drawer to unwind the hoses and then
place the drawer on the runners, making
sure the hoses are looping upward.
Close the bottom drawer.
11. Use the side cutting pliers to carefully cut
the two cable ties securing the hoses and
power supply cord to the back of the
dishwasher.
Completely remove the power supply cord
and save it in case a power cord installa-
tion is needed in the future.
WARNING
Tip Over Hazard
Do not open dishwasher drawer until
inside cabinet opening.
Doing so can cause serious injury.
12. Route the hoses through the utility hole.
IMPORTANT: Push against the outside
edges of the drawers as shown. Do not
push against the middle of the drawers.
WARNING
Excessive Weight Hazard
Use two or more people to move and
install dishwasher.
Failure to do so can result in back or
other injury.
Push the dishwasher partway into the
opening.
As the dishwasher is being pushed into
the opening, carefully pull the inlet hose
and drain hose through the utility hole.
Allow the house wiring to gather behind
the dishwasher.
Remove the strap from upper drawer.
13. If the cabinet opening is 24" wide x 34-12"
high (61.0 cm x 87.6 cm), flexible extru-
sions can be attached along the top and
sides of the dishwasher. The top and side
extrusions are different lengths.
chassis
trim
edge
side
extrusion
2-9
side
extrusion
lip
side
top extrusion
extrusion
chassis
open drawer
trim
edge