Samsung iDCS 500 Technical Manual page 27

iDCS 500 Release 2 / OfficeServ
TECHNICAL MANUAL
ON (left)
4 DIGIT STATION NUMBERS
4 DIGIT STATION GROUPS
4 DIGIT TRUNK NUMBERS
COUNTRY SELECT
COUNTRY SELECT
COUNTRY SELECT
COUNTRY SELECT
Switches 1 through 4 select the country the system is installed in.
4
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
Switch 5 reserved.
These DIP switches will not take effect unless the switches are set in the wanted
position and the system memory is cleared manually by using the Memory Backup
switch.
Install the SmartMedia card. Install daughter board(s). Set the MCP2 DIP switches on the
card to the desired positions. Turn the memory switch on.
Insert MCP2 card in the Cabinet slot labeled MCP/LCP
the top and bottom of the card to ensure that it is fully inserted into the back plane
connector. To prevent accidental damage to the MCP2 card, the MCP/LCP connector
on the back plane is positioned to mate only with the MCP2 or LCP2 card. Other
interface cards will not mate with this connector and the MCP2 card will not mate with
any other connector. NOTE: Do not insert this card with system power ON.
DIP SWITCH USE
on the
iDCS 500 MCP2
SW8
SW7
SW6
RESERVED SW5
SW4
SW3
SW2
SW 1
3 2
OFF OFF
OFF OFF
OFF ON
OFF ON
ON OFF
ON OFF
ON ON
ON ON
3.4
Home Page
PART 3 MARCH 2004
OFF (right)
3 DIGIT STATION NUMBERS
3 DIGIT STATION GROUPS
3 DIGIT TRUNK NUMBERS
RESERVED
COUNTRY SELECT
COUNTRY SELECT
COUNTRY SELECT
COUNTRY SELECT
1 Country
OFF Korea
ON USA
OFF UK
ON Italy
OFF Australia
ON New Zealand
OFF Holland
ON Denmark
(see Figure 3–1). Push firmly at
Table of Contents
INSTALLATION