Samsung iDCS 500 Technical Manual page 136

iDCS 500 Release 2 / OfficeServ
TECHNICAL MANUAL
11.2 INSTALLATION OF THE SVMi-8/SVMi-16E
Follow the steps below to ensure that the SVMi-8/SVMi-16E is properly setup.
1. INSPECTION
Unpack and inspect the unit for obvious damage. This card should be labeled
SVMi-8/SVMi-16E. If it is not, you have the wrong card.
2. INSERTING THE CARD
Check that the iDCS power switch is the OFF position. The SVMi-8/SVMi-16E card is
installed in any universal slot of any cabinet. Next position the SVMi-8/SVMi-16E
card in the grooves of the card guide and gently slide the card in until it makes
contact with the connector. Press gently but firmly on the top and bottom of the
front edge of the card until the card sits in its connector.
3. POWER UP
Complete installation of all other required iDCS interface cards and turn the iDCS
power switch ON.
4. CONFIRM OPERATION
On the SVMi-8 wait for the ACT LED to be either OFF or ON steady green. Either of
these conditions indicates normal operation as defined in the table above. On the
SVMi-16E the PGD must be red, and the AP/D and SD LEDS must be red as well.
5. iDCS PROGRAMMING
Perform the following iDCS programming steps A through F. It is necessary to
perform these at this time so that the SVMi-8/SVMi-16E will read these MMCs and
initialize accordingly.
MMC 601: All SVMi-8/SVMi-16E ports must be assigned to group 529/549.
MMC 601: Select either SEQUENTIAL or DISTRIBUTED ring mode.
MMC 207: Set SVMi-8/SVMi-16E ports for VMAA use. This will be done
automatically. You are just confirming at this point.
If you are using SVMi-8/SVMi-16E for Auto Attendant use MMC 406
and/or MMC 714 to set the desired trunk(s) to ring group 529/549.
If you are using SVMi-8/SVMi-16E for Voice Mail make sure that all
desired stations are forwarded to group 529/549.
MMC 741: Select "NO" for each station that you DO NOT want to create a
mailbox for.
6. INITIALIZE SVMi-8/SVMi-16E. Use MMC 746 to halt or shutdown the SVMi, then
press the red RST button to read these MMCs and initialize SVMi-8/SVMi-16E
accordingly.
Home Page
11.2
Table of Contents
INSTALLATION
PART 11 MARCH 2004