Product Overview; Operation; Installing And Removing The Weights - Toro Sand Pro 2040Z Operator's Manual

Product Overview

2 3
1
8
Figure 12
1. Cable
2. Boom
3. Lift chains
4. Frame bracket
4 5
7 6
G024508
5. Stop-chain assembly
6. Drawbar
7. Drawbar bracket
8. Rake

Operation

Installing and Removing the
Weights
The flex tooth rake requires 4 weights, which are included
with the machine. Always ensure that your machine has the
appropriate number of weights.
Refer to the following table for how many weights are
required on the front of the machine:
Attachment
Flex tooth rake
Flex tooth rake with finish brush
Nail drag
Nail drag with finish drag mat
1. Remove the 2 bolts and 2 nuts securing the existing
weights on the front of the machine (Figure 13).
Note: If the machine is equipped with the light kit,
remove the nut and the bolt securing the front light to
the machine. Retain all of the parts; refer to the Light
Kit Installation Instructions.
2. Add or remove weights as necessary.
3. Secure the weights with the 2 bolts and the 2 nuts.
Note: If the machine is equipped with the light kit,
install the front light by inserting the bolt through the
8
Number of weights required
4
6
6
8
G023729
Figure 13