Z-Wave™ Operation And Programming; Inclusion; Exclusion; Inclusion And Exclusion - Trane Z WAVE TZEMT400AB32MAA User Manual

Z-Wave™ Operation and Programming
Z-Wave™ controllers from various manufacturers may support the Z-Wave™ Thermostat General V2 Device class used
by the Trane Z-Wave™ Thermostat. The following procedure will allow the thermostat to be added to a Z-Wave™ network.
If you are using a controller that is not a Schlage bridge, consult the instructions that came with the controller to find out
how to enroll a new device.

Inclusion

a. Hold the bridge within 6 feet (1.8 meters) of the thermostat throughout all of step 2.
Note: After you begin the enrollment process, you have 30 seconds to complete the remainder of the
steps. Study the steps below before beginning.
b. Press and release the plus (+) button on the bridge.
c. Press the MENU button on the thermostat.
d. Scroll down to
e. Press the Yes button to enroll the thermostat.
f. Observe the lights on the bridge. The orange light will blink while enrollment is taking place. Enrollment is
complete when the orange light becomes solid.

Exclusion

a. Hold the bridge within 6 feet (1.8 meters) of the thermostat throughout all of step 2.
Note: After you begin the enrollment process, you have 30 seconds to complete the remainder of the
steps. Study the steps below before beginning.
b. Press and release the minus (-) button on the bridge.
c. Press the MENU button on the thermostat.
d. Scroll down to
e. Press the Yes button to exclude the thermostat.
f. Observe the lights on the bridge. The orange light will blink while exclusion is taking place. Exclusion is
complete when the orange light becomes solid.

Inclusion and Exclusion

Inclusion or exclusion is started by putting the controller into add node or remove node state and performing the procedure
outlined above. As part of the process, the thermostat sends a node information frame at normal power. Low power
inclusion or low power exclusion is not possible.
4
Z-Wave Install, and press the Select button.
Z-Wave Install, and press the Select button.