E362 Engine Overspeed - Perkins 1106D Troubleshooting Manual

KENR6201-01
Table 33
Engine Model
Trip Level
Delay to activation
System Response:
The event code will be logged.
The warning lamp will be illuminated and the
diagnostic lamp will flash the event code.
Possible Performance Effect:
E361-1 There is no performance effect.
None
E361-2 The engine will be derated at a rate of one
percent per second.
The derate lamp will be illuminated.
E361-3 The shutdown lamp will be illuminated.
The ECM will shut down the engine after two seconds
when the trip level has been reached.
A shutdown of the engine will only occur if the "Enable
Shutdown" customer programmable parameter has
been enabled.
Troubleshooting:
Refer to Troubleshooting, "Coolant Temperature Is
Too High".
Results:
•
OK – STOP.

E362 Engine Overspeed

Conditions Which Generate This Code:
The engine speed is above the trip point for engine
overspeed. Refer to Table 34.
Note: This event code represents an event. This
does not represent an electronic system fault.
This document is printed from SPI². Not for RESALE
Engine Coolant Trip Level Table
E361-1
113 °C (233 °F)
10 seconds
i03813909
Troubleshooting Section
E361-2
114° C (237° F)
10 seconds
97
E361-3
118 °C (244 °F)
2 seconds