Perkins 1106D Troubleshooting Manual page 12

12
Troubleshooting Section
•
Sensor calibrations
•
Programming of flash files
•
Parameter programming
•
Copy configuration function for ECM replacement
•
Data logging
•
Graphs (real time)
Table 3 lists the service tools that are required in
order to use the Electronic Service Tool.
Table 3
Service Tools for the Use of the Electronic
Part
Number
-
(1)
Single Use Program License
-
(1) Data Subscription for All Engines
Communication Adapter (Electronic
27610251
Service Tool to ECM interface)
27610164
Adapter Cable As
(1) Refer to Perkins Engine Company Limited.
Note: For more information regarding the use of the
Electronic Service Tool and the PC requirements
for the Electronic Service Tool, refer to the
documentation that accompanies your Perkins
Electronic Service Tool software.
This document is printed from SPI². Not for RESALE
Service Tool
Description
Connecting the Electronic Service Tool
and the Communication Adapter II
Illustration 3
(1) Personal Computer (PC)
(2) Adapter Cable (Computer Serial Port)
(3) Communication Adapter II
(4) Adapter Cable Assembly
Note: Items (2), (3) and (4) are part of the
Communication Adapter II kit.
Use the following procedure in order to connect
the Electronic Service Tool and the Communication
Adapter II.
1. Turn the keyswitch to the OFF position.
2. Connect cable (2) between the "COMPUTER"
end of communication adapter (3) and the RS232
serial port of PC (1).
Note: The Adapter Cable Assembly (4) is required to
connect to the USB port on computers that are not
equipped with a RS232 serial port.
3. Connect cable (4) between the "DATA LINK" end
of communication adapter (3) and the service tool
connector.
4. Place the keyswitch in the ON position. If the
Electronic Service Tool and the communication
adapter do not communicate with the Electronic
Control Module (ECM), refer to the diagnostic
procedure Troubleshooting, "Electronic Service
Tool Will Not Communicate With ECM".
KENR6201-01
g01121866