E362 Engine Overspeed; E363 High Fuel Supply Temperature - Perkins M190C Troubleshooting Manual

KENR9126
None
E361-2
The ECM will derate the power at 1 percent per
second.
Troubleshooting:
Refer to Troubleshooting, "Coolant Temperature Is
Too High".
Results:
• OK – STOP.

E362 Engine Overspeed

Conditions Which Generate This Code:
The engine speed is above 2840 RPM for more than
0.6 seconds.
Note: This event code represents an event. This
does not represent an electronic system fault.
System Response:
If equipped, the diagnostic lamp will come on and the
event code will be logged.
The ECM will reset the event when the engine speed
is lower than 2640 RPM for 0.6 seconds.
Possible Performance Effect:
E362-1
The fuel injection will be disabled until the event has
been reset.
Troubleshooting:
This event indicates excessive engine speed. This
event does not represent a fault in the Engine Control
Module (ECM).
This event does not represent a fault in the Electronic
Speed/Timing Sensor.
No troubleshooting is required.
Results:
• OK – STOP.
E363 High Fuel Supply
Temperature
Conditions Which Generate This Code:
This event code will only be generated if the switch
for the fuel temperature is installed and correctly
wired to the ECM. The feature must be enabled
in the customer programmable parameters on the
electronic service tool.
The fuel temperature has exceeded the trip point.
Refer to Troubleshooting, "Event Codes" for the trip
i04012512
point.
System Response:
The Electronic Control Module (ECM) will log the
event.
Possible Performance Effect:
• There are no performance effects.
Troubleshooting:
Check the Fuel System
A. Check the heat exchanger (if equipped). Verify
that the heat exchanger is free of debris and of
obstructions.
Expected Result:
A thorough inspection of the heat exchanger revealed
a problem.
Results:
•
OK – There is a problem with the heat exchanger.
Repair: Make the necessary repairs. Verify that
the repair eliminates the problem.
STOP.
• Not OK – There is a problem with the fuel system.
Repair: Repair the problem.
Ensure that the repair eliminates the problem.
STOP.
109
Troubleshooting Section
i04018249