TP-Link TL-MR3420 User Manual page 12

Chapter 2
Note:
• If the Wi-Fi LED ( ) is off, press the Wi-Fi button on the rear panel for 3 seconds and then check the LED again.
2. Connect your computer to the router.
• Method 1: Wired
Turn off the Wi-Fi on your computer and connect the devices as shown below.
• Method 2: Wirelessly
1 ) Find the SSID (Network Name) and Wireless Password printed on the label at
the bottom of the router.
2 ) Click the network icon of your computer or go to the Wi-Fi settings of your
smart device, and then select the SSID to join the network.
Connections are available
Wireless Network Connection
TP-LINK_XXXX
Connect automatically
• Method 3: Use the WPS button
Wireless devices that support WPS, including Android phones, tablets, most USB
network cards, can be connected to your router through this method.
Note:
• WPS is not supported by IOS devices.
• The WPS function cannot be configured if the wireless function of the router is disabled. Also, the WPS function
will be disabled if your wireless encryption is WEP. Please make sure the wireless function is enabled and is
configured with the appropriate encryption before configuring the WPS.
1. Tab the WPS icon on the device's screen. Here we take the Android phone for instance.
2. Within two minutes, press the WPS button on your router.
Power Wi-Fi Internet
On On On
Wired
< Settings
Wi-Fi
CHOOSE A NETWORK...
Connect
TP-LINK_XXXX
Other...
Connect the Hardware
Wi-Fi
11