Advertisement
Available languages
Available languages
► Rear FIG. 3
6. Air Filter/ Air inlet
7. Water Tank
8. Power cable
►►
5. OPERATION
►
1. Plug the unit into a correct mains socket. (Please refer to
the rating label at the rear of the unit.)
2. Press button ON/OFF to turn on the unit. The compres-
sor will start to work in continuous mode.
3. To turn off the unit, press button ON/OFF again.
►►
6. DRAINAGE
►
While the water tank is full, the compressor will stop for
self-protection and the water full indicator will turn into red.
To move the water tank, pull it out squarely from the unit.
After empting the water tank, place the water tank into spa-
ce. Make sure it is properly positioned, in order for the 'wa-
ter full' sign to go out and your dehumidifier is operating.
Please note, in case, the water tank has not been positio-
ned well, the water full indicator will turn into red.
►►
CONTINUOUS DRAINAGE
►
When the dehumidifier is operated at very high humidity
levels, the water tank will require more frequent drainage.
In this situation, it may be more convenient to set the unit
up for continuous drainage with the following procedures:
1. Pull out the water tank (FIG. 4).
2. Connect the drain hole with water tube of inner diame-
ter: 11 mm. The water tube is not supplied with the unit
(FIG. 5).
3. Ensure the water will always drain away freely and the
tube will remain in right place. Note! In very cold weather
conditions, precautions should be taken to prevent the wa-
ter tube from freezing.
4. Put the water tank back to its position (FIG. 6).
►►
7. MAINTENANCE
►
Always unplug the unit from the mains before carrying out
any maintenance or cleaning of the unit.
CLEANING THE BODY
Use soft cloth to wipe the unit clean.
Don't ever use volatile chemicals, gasoline, detergents,
chemically treated clothes, or other cleansing solutions.
These all could possibly hurt the cabinet.
CLEANING THE FILTER
This dehumidifier is equipped with 2 filters (FIG. 7):
1. ANTI-DUST FILTER
Extract the filter holder, remove the active carbon filter.
Use a vacuum cleaner or tap the filter lightly for easy clea-
ning. If the filter is particularly dirty, use warm water with
a small amount of a small amount of medium strength
detergent.
Make sure the filter is completely dry before replacing.
Do not expose the filter to sunlight.
2. ACTIVE CARBON FITLER (for capturing the particles
of dust suspended in the air and preventing the produc-
tion of bacteria.)
The active carbon filter placed under the anti-dust filter is
not washable. Its life span is variable and depends on the
ambient conditions where the unit is used. The filter should
be checked periodically and replaced if necessary.
STORAGE
If not use the unit for an extended period of time. Please:
Turing the unit off, unplug and tidy AC cord.
► Completely empty the water tank and wipe it clean.
► Cover the unit and store where it will not receive direct
sunlight.
►►
8. TROUBLE SHOOTING
►
THE UNIT DOES NOT OPERATE:
► Is the unit plugged in?
► Is the house electricity on?
► Is the room temperature below 5
so, then it is out of the working range of the unit.
► Ensure the humidistat (or ON/OFF switch) is turned
on.
► Check the water tank is positioned properly in the unit
and it is not full.
► Make sure the air inlet and outlet are not obstructed.
THE UNIT SEEMS TO DO NOTHING:
► Is the filter dusty, contaminated ?
► Is the air intake or outlet blocked up?
► Is the room humidity already quite low?
THE UNIT SEEMS TO DO LITTLE:
► Are too many windows or doors open?
► Is there something in the room producing lots of humi-
dity?
THE UNIT IS TOO NOISY:
► Check whether the unit is sitting on a level surface.
THE UNIT IS LEAKING:
► Make sure the unit is in good shape.
► If you are not using continuous drainage, make sure the
rubber plug (at the bottom of the unit) is in its position.
en
CZ
DE
DK
EE
ES
C or above 35
C? If
O
O
FI
FR
GB
HR
HU
IT
LT
LV
NL
NO
PL
RO
RU
SE
SI
SK
UA
SE
SI
SK
TR
UA
Advertisement
