Table Of Contact Id Event Codes - ADEMCO N7227V5 Installation And Setup Manual

Vista security system installation and setup guide

Hide thumbs Also See for Ademco N7227V5:

Installation instructions manual (88 pages)

Table Of Contents

100

page of 100

/ 100
Contents
Table of Contents
Bookmarks

Table of Contents

VISTA-10SE Installation and Setup Guide

The following describes each format in greater detail.

3+1 and 4+1 Standard Formats

3+1 and 4+1 Expanded Formats

4+2 Format

ADEMCO Contact ID

Reporting Format

ADEMCO Contact ID Reporting takes the following format:

where: CCCC = Customer (subscriber) ID

NOTE: For a complete list of event codes, refer to the central office receiver manual.

Code

Definition

110

Fire Alarm

121

Duress

122

Alarm, 24-hour Silent

123

Alarm, 24-hour Audible Panic

131

Alarm, Perimeter, Burg.

132

Alarm, Interior, Burg.

134

Alarm, Entry/Exit, Burg.

135

Alarm, Day/Night, Burg.

150

Alarm, 24-Hour Auxiliary

301

AC Power

302

Low System Battery/Battery Test Fail

321

Bell/Siren Trouble

333

Expansion Module Fail

344

Trouble, RF Jam Detect

353

Long-Range Radio Trouble

System Communication Programming

Programming information of those data fields that affect communications between the

control and the central station is included in the sections DATA FIELD DESCRIPTIONS and

ZONE PROGRAMMING ( 56 and 58 menu modes).

20-2

Comprise a 3- (or 4-) digit subscriber number and a single-digit

report code (e.g., Alarm, Trouble, Restore, Open, Close, etc.).

Comprise a 3- (or 4-) digit subscriber number, and a two-digit re-

port code. The first digit is displayed on the first line. On the

second line, the first digit is repeated 3 (or 4) times and is

followed by the second digit. This is the "expanded" digit.

Comprises a 4-digit subscriber number and 2-digit report code.

Comprises a 4-digit subscriber number, 1-digit event qualifier

("new" or "restore"), 3-digit event code, and 3-digit zone number,

user number, or system status number (see the following page).

CCCC Q EEE GG ZZZ

Q = Event qualifier, where:

E = new event , and R = restore

EEE = Event code (3 hexadecimal digits)

GG = Always 00.

ZZZ = Zone/contact ID number reporting the alarm, or user number for open/close reports.

System status messages (AC Loss, Walk Test, etc.) contain zeroes in the ZZZ location.