Sony MSU-900 Operation Manual page 77

1
[MSU SW Set]
Press on the MSU Configuration
menu.
The MSU SW Setting display appears.
MSU SW Setting
PIX/WF PIX/WF
All Mode
Synchro
ON ON
Screen Saver
Wait
Time
5
ON
PIX/WF Synchro setting
Specify whether to switch the outputs from the PIX2
OUTPUT and WF2 OUTPUT connectors in
synchronization with RGB switching on the adjustment
display in white or black shading adjustment.
[ON]
Press the button to turn on or off the synchronization.
[ON]
On (when the button is highlighted): The outputs
from the PIX2 OUTPUT and WF2 OUTPUT
connectors are switched in synchronization with RGB
switching on the adjustment display in white or black
shading adjustment.
Off: The PIX2 OUTPUT and WF2 OUTPUT connectors
output the signal selected with the PICTURE
MONITOR or WAVEFORM MONITOR buttons on
the control panel regardless of RGB switching on the
adjustment display.
PIX/WF All Mode setting
Turn on or off PIX/WF All mode.
[ON]
Press the button to turn on or off the mode.
[ON]
On (when the button is highlighted): The
PICTURE MONITOR and WAVEFORM MONITOR
buttons have effect on all the connected cameras of the
same group.
Off: The PICTURE MONITOR and WAVEFORM
MONITOR buttons have effect only on a camera
selected with the camera select button.
PIX/WF Control Mode setting
Select the operation mode of the monitor output select
buttons.
Press and highlight either button.
[Direct]
: Direct mode.
When you press and light any of the R, G, and B
buttons of the PICTURE MONITOR and
WAVEFORM MONITOR buttons, the previously
depressed and lit button goes dark and the signal
corresponding to the newly pressed and lit button is
output.
To output R and G signals, press the G button while
holding down the R button.
Exit
PIX/WF Control
Mode
Alter-
Direct
nate
[Alternate]
: Alternate mode.
When you press and light any of the R, G, and B
buttons of the PICTURE MONITOR and
WAVEFORM MONITOR buttons, the signal
corresponding to the newly pressed and lit button is
output in combination with that corresponding to the
previously pressed and lit button.
In this case, to output R and G signals, press to light the
R button first, then press and light the G button. If the
B button is lit, press it so that it goes dark.
When the settings are completed
[Exit]
Press to exit this menu.
77
Initial Settings