Sony MSU-900 Operation Manual page 53

c GAMMA display window
The currently selected step gamma value is displayed in
the window.
The setting is made using the Function menu.
The lower the value, the higher the gamma effect.
d MASTER GAIN display window
The selected gain value (dB) of the camera is displayed in
the window.
The setting is made using the Function menu.
e Filter display window
The currently selected ND and CC filters are
displayed. Filter selection is made using the Function
menu.
ND filter (Examples)
1: Clear
2: 1/4 ND
3: 1/8 ND
4: 1/16 ND
5: 1/64 ND
CC filter (Examples)
A: Cross filter
B: 3200K (clear)
C: 4300K
D: 6300K
E: 8000K
For the Function menu, see pages 60 and 68.
qd PICTURE MONITOR buttons
(MSU-900 only)
Press to select the output signal from the PIX2 OUTPUT
connector of CCU.
The signal corresponding to the lit button is output.
R/G/B: Select the R signal, G signal, or B signal. The
signals can be selected either independently or in
combination. When any of these buttons is pressed, the
ENC (encode) circuit is turned off.
ENC (encode): When this button is pressed, the R/G/B
circuits are turned off, and the ENC signal is output.
qf WAVEFORM MONITOR buttons
(MSU-900 only)
Press to select the output signal from the WF2 OUTPUT
connector of the CCU.
The signal corresponding to the lit button is output.
R/G/B: Select the R signal, G signal, or B signal. The
signals can be selected either independently or in
combination. When any of these buttons is pressed, the
SEQ (sequence) and ENC (encode) circuits are turned
off.
SEQ (sequence): When this button is pressed, the R/G/B
and ENC circuits are turned off, and the SEQ signal is
output. You can monitor the waveforms of the three R,
G, and B signals in sequence on a waveform monitor.
ENC (encode): When this button is pressed, the R/G/B
and SEQ circuits are turned off, and the ENC signal is
output.
Locations and Functions of Parts
53