Lincoln Electric PIPEFAB Series Operator's Manual page 64

PIPEFAB™ WELDING SYSTEM
FCAW HOME SCREEN
FIGURE B.10
1. Feedhead Indicator – Shows which side of the wire feeder is selected and ready for setup. The
ac�ve side can be selected by pressing the Feedhead Select Switch, Cold Feed Switch, or the gun
trigger for the desired side.
2. Menu Bar - Use the Menu knob to scroll through the op�ons along the bo�om of the screen.
Press the knob to select the highlighted op�on.
3. Wire Feed Speed Se�ng - Sets the desired wire feed speed, use le� knob to adjust.
4. Voltage Se�ng - Sets the voltage, use right knob to adjust.
5. Wire Diameter Selec�on
6. Gas Type Selec�on
7. 2-Step/4-Step Trigger Interlock - Toggles between 2-Step and 4-Step Trigger Interlock. 2-Step
provides weld power and feeds wire only when the trigger is depressed. 4-Step eliminates the
need to hold the trigger while welding. It operates in 4 steps:
1.
2.
3.
4.
NOTE: No symbol will be shown if 2-Step mode is ac�ve.
Close trigger and establish welding arc.
Release trigger and con�nue welding.
Reclose trigger near end of weld.
Release trigger again to stop welding.
B-13
OPERATION